0280158829 Fuel Injectors Set of 8, 210lb/hr 2200cc High Flow Injector for Honda Audi Mazda GM, Replacement for 02801-58829 for Performance E85 Turbo Builds

Product SpecificationsPart Number: 0280158829 / 02801-58829Quantity: Set of 8 injectorsFlow Rate: 210 lb/hr (approximately 2200 cc/min) at 43.5 PSI (3 Bar)Fuel Type: Gasoline, E85Impedance: High impedance (12 ohms nominal) - compatible with most ECUsSpray Pattern: Cone sprayConnector Type: EV1 / USCAR (minitimer) styleO-Ring Sizes: Upper and lower (replace during installation)Application: High horsepower forced induction / E85 performance enginesPerformance Application GuidelinesTurbo/Supercharged (Gasoline): Suitable for 600-1000+ HP depending on fuel system and boost.Turbo/Supercharged (E85): Suitable for 500-700+ HP (E85 requires 30-40% more fuel volume than gasoline).ECU Requirement: Aftermarket standalone or piggyback with injector scaling capability.Base Fuel Pressure: Rated at 43.5 PSI (3 Bar). Adjust fuel pressure regulator within 40-60 PSI range as needed for your performance build.Compatible Brands (Performance Applications)For Honda (performance builds - For Civic, For Accord, For Prelude, S2000 with forced induction)For Audi (turbo builds - 1.8T, 2.7T, 4.2L with high HP goals)For Mazda (RX7, RX8, Mazdaspeed 3/6 with upgraded turbo)For Dodge (SRT4, Neon, Caliber with high HP turbo builds)For GM (LS series, EcoTech with forced induction)For Volkswagen (1.8T, 2.0T, VR6 turbo builds)For Acura (NSX, Integra, RSX, TL turbo builds)High Flow Injector FunctionFuel Delivery: Each 0280158829 injector sprays metered fuel into intake port or direct port injection locationECU Control: Pulse width modulated signal - shorter pulse for low load, longer pulse for high loadHigh Impedance: 12 ohm coils compatible with most aftermarket ECUs without resistors or peak/hold driversE85 Compatibility: Internal components resist ethanol corrosion - suitable for E85 up to 85% ethanolFailure Impact of 210lb Injectors on Stock Engine: Engine will run extremely rich (12:1 or lower) and may not idle. Catalytic converter damage possible.Signs Your High HP Build Needs These InjectorsCurrent injectors at 90%+ duty cycle at peak power: Stock injectors running out of fuel capacity on your boosted engineLean condition (AFR above 12.5:1) under boost: Fuel system cannot keep up with air flow on your turbo buildUpgrading turbo or supercharger: Higher airflow requires proportional increase in fuel delivery capacity

• 📋 Part Number Verification - 0280158829 fuel injector replaces for number 0280158829 and 02801-58829. The 210lb/hr high flow injector is not for stock engines. Before ordering these 2200cc injectors for Honda or for Audi, verify your engine management system can control them. These 0280158829 injectors require aftermarket ECU or tuning.
• ⛽ High Flow Specifications - 0280158829 injectors flow 210lb/hr (approximately 2200cc/min) at 43.5 PSI (3 Bar). The 2200cc high impedance injectors are designed for high horsepower forced induction applications. Use these 210lb injectors for E85 or race fuel builds on your Mazda or GM vehicle. Not for naturally aspirated stock engines.
• ⚠️ Performance Application Only - 0280158829 injector set is for modified engines only. The 210lb/hr flow rate is excessive for naturally aspirated or lightly modified engines for Honda or for VW. Stock ECU cannot control 2200cc injectors.
• 🔧 Tuning Required - Before installing these 0280158829 high flow injectors for GM or for Honda, have your vehicle professionally tuned. The 210lb injectors will not idle correctly without proper ECU calibration. Base fuel pressure may need adjustment for the 2200cc injectors on your performance engine. Do not install these 0280158829 injectors without tuning capability.
• ⚙️ E85 Compatibility - These 0280158829 injectors are compatible with gasoline and E85 blends. The 210lb/hr flow rate at 3 Bar provides sufficient fuel volume for E85 conversions on high horsepower engines. For E85 use for Dodge or for Mazda, increase injector duty cycle by approximately 30-40% compared to gasoline tuning. These 2200cc injectors support 800+ HP on gasoline, 500-600 HP on E85.